On Thu, Feb 02, 2006 at 07:09:06PM +0100, Norbert Klamann (pr) wrote:
> Hello all,
> i have some trouble with vservers. I use debian sarge and proceeded
> verbatim along this instructions
> http://linux-vserver.org/Step-by-Step+Guide+2.6
>
> including the versions mentioned there.
>
> Everything goes fine except this step :
> ----
> # It's a good point to fix the /proc entries for the guests
> /etc/init.d/vprocunhide restart
>
> ----
> vprocunhide does not exist there
>
> I tried make install-distribution but no avail.
>
>
> testme.sh works fine
>
>
> I create a vserver based on sarge and clean up the init-scripts as
> recommended.
>
> When I start the server I get the following error: /proc/uptime cannot
> be accessed. Usually etc .....
>
> The script exists in the source directory of the alpha-tools but I am
> stucked here. Can you help me ?
IIRC, after you ./configured and built (make) the
tools (util-vserver) you do the 'make install' which
installs the binaries and scripts, and writes a short
message which informs you to do the distro specific
install too
'make install-distribution'
which should setup scripts and helpers (sysv) for your
distribution (see README for details)
after that, whatever path was configured for your
install (they are somewhat strange on debian, but
check with 'vserver-info - SYSINFO' if you didn't
look at the ./configure output), will contain the
vprocunhide runlevel script, which just has to be
executed once at system startup ...
HTH,
Herbert
> I try no to switch off the PROC in thge kernel options but I have to
> admit that I am not shure what I am doing there...
>
> Thanks for listening
>
>
>
>
>
> --
> Greetings
>
> Norbert
> _______________________________________________
> Vserver mailing list
> Vserver@list.linux-vserver.org
> http://list.linux-vserver.org/mailman/listinfo/vserver
_______________________________________________
Vserver mailing list
Vserver@list.linux-vserver.org
http://list.linux-vserver.org/mailman/listinfo/vserver
Received on Fri Feb 3 01:39:41 2006