On Wed, 16 Nov 2005 10:35:50 +0100, Bernd Petrovitsch wrote:
>On Wed, 2005-11-16 at 09:14 +0000, Lyn St George wrote:
>> On Wed, 16 Nov 2005 02:17:30 +0100, Herbert Poetzl wrote:
>>
>> >> Please tell if you have a solution?.
>> >
>> >just change 127.0.0.1 to your first guest IP in your
>> >config files, and everything should work fine ...
>>
>> I can confirm that it works fine if you do that, ie use an
>> IP in the named.conf file
>
>And add "localhost" as hostname in thwe vserver's /etc/hosts for the
>eth0 IP address. Then you can use "localhost" as usual (as hostname) and
>it should word.
Yes, I've also done that in another vserver running Postfix + amavisd,
which needs to run 127.0.0.1 on ports 10024 and 10025. But I also take
note of Herbert P's previous comment to the effect that this may not
be entirely safe with the curent networking code (or least that is how
I understood it - I can't find that message now to check). Possibly
it may be safe enough if done in one vserver, but not in more than one?
> Bernd
>--
>Firmix Software GmbH http://www.firmix.at/
>mobil: +43 664 4416156 fax: +43 1 7890849-55
> Embedded Linux Development and Services
>
>
-
Lyn
_______________________________________________
Vserver mailing list
Vserver@list.linux-vserver.org
http://list.linux-vserver.org/mailman/listinfo/vserver
Received on Wed Nov 16 10:24:20 2005