From: Chris Besignano (chris_at_linsoftlabs.com)
Date: Thu 11 Mar 2004 - 13:41:09 GMT
I need to run a few different websites on my box using vservers. What
method does everyone use to route the traffic from eth1 (externel
interface, real ip) to the vservers bound to eth0 (internal ip,
192.168.x.x network)?
Darryl Ross wrote:
> Dariush Pietrzak wrote:
>
>>> services in the host to ONLY bind the host's IP address, instead of all
>>
>>
>> Not true.
>>
>> The whole point of vservers networking is that you can give some ip
>> to thw
>> whole server, and then when services inside bind to '0.0.0.0' they
>> get anlo
>> what was allocated for given vserver.
>> If what you say was true, there wouldn't be much difference between
>> vserver setup and chrooted services.
>
>
> Did you read what he said??
>
> As per your quote above, emphasis is mine:
>
> > services in the __host__ to ONLY bind the __host's__ IP address
>
> which is exactly what you want to do. If you need to run a service in
> the host, as well as inside the vservers (eg, ssh), you need to tell
> the host sshd to only bind to the main IP, not the IP addresses of all
> the vservers.
>
> Cheers
> Darryl
> _______________________________________________
> Vserver mailing list
> Vserver_at_list.linux-vserver.org
> http://list.linux-vserver.org/mailman/listinfo/vserver
>
_______________________________________________
Vserver mailing list
Vserver_at_list.linux-vserver.org
http://list.linux-vserver.org/mailman/listinfo/vserver